Garmin G1000 Maintenance Manual

____________________________________________________________________
G1000 System Maintenance Manual Page 4-1
190-00903-00 Rev. A
SECTION 4
CONFIGURATION MODE
This section describes the configuration mode of operation. This section presumes basic
familiarity with the operation of the G1000.
4.1 INTRODUCTION
Configuring, calibrating, and troubleshooting the G1000 is performed in the configuration mode.
To enter configuration mode:
1. Press and hold the ENT key on the PFD while applying power. Release the ENT key after
‘INITIALIZING SYSTEM’ is displayed in the upper left corner of the PFD.
2. Repeat step 1 for PFD 2 (if installed). The System Status Page (Figure 4-1) is displayed on
the MFD and the PFD.
3. Press the 12
th
softkey on GDU 1xxx that does not have an ENT key to enter Config Mode.
Figure 4-1. System Status Page (Configuration Mode)

Garmin G1000 Specifications

General

Display Type	LCD
Primary Flight Display (PFD)	Yes
Multi-Function Display (MFD)	Yes
Terrain Awareness	Yes
Autopilot Integration	Yes
Integrated Flight Deck System	Yes
Weather Radar	Optional
Traffic Advisory System (TAS)	Optional
Terrain Awareness and Warning System (TAWS)	Yes
Resolution	1024 x 768 pixels
Weather Data	Yes
Navigation	Yes
AHRS	Yes
Air Data Computer (ADC)	Yes
Interfaces	ARINC 429, RS-232
Certification	TSO certified
Traffic Information	Optional (requires ADS-B or TCAS)