5 REAR PANEL
The MiCOM P40Agile Modular series uses a modular construction. Most of the internal workings are on boards and
modules which fit into slots. Some of the boards plug into terminal blocks, which are bolted onto the rear of the
unit. However, some boards such as the communications boards have their own connectors. The rear panel
consists of these terminal blocks plus the rears of the communications boards.
The back panel cut-outs and slot allocations vary. This depends on the product, the type of boards and the
terminal blocks needed to populate the case. The following diagram shows the rear view of a 40TE. The IEC
61850-9-2LE interface is highlighted in grey.
Figure 7: Rear view of populated case
Note:
This diagram is a typical example and may not show the exact same arrangement of boards as your particular model. Refer
to the Cortec for product details.
Chapter 3 - Hardware Design P446SV
38 P446SV-TM-EN-1
To Next Page
Loading...
Need help?
General