NetworX Version 3 Installation Manual
186
Term Definition
Time Unit A menu option that specifies the time unit (set in Control Output Events>Time
option) as minutes or seconds.
Traceability A menu entry that groups additional information, like serial number,
manufacture date, and firmware revision for the particular IO module/siren.
Traceability A menu entry that groups additional information, like serial number,
manufacture date, and firmware revision.
Unit Code A menu option that sets the X-10 unit number used to identify a particular X-10
device on the selected module.
Version A menu option that displays the current software version of the selected
receiver.
Voltage Level A menu entry that displays battery voltage level and auxiliary voltage level for
the particular IO module/siren.
Wake On Entry Timer When this option is set to Enabled, all the wireless keypads get active on Entry
Timer start, i.e. they wake up from the sleep mode in order to indicate it . When
this option is set to Disabled, keypads do not wake up.
Wake On Exit Timer When this option is set to Enabled, all the wireless keypads get active on Exit
Timer start, i.e. they wake up from the sleep mode in order to indicate it. When
this option is set to Disabled, keypads do not wake up.
Wake On Pulsing Buzzer When this option is set to Enabled, all the wireless keypads get active on
Pulsing Buzzer, i.e. they wake up from the sleep mode in order to emit it. When
this option is set to Disabled, keypads do not wake up, and sound is not
emitted. Please note, that also other keypad settings can affect whether the
acoustic signal is actually emitted or not, for example, Keypad Features>Silent
Keypad.
Wake Up On Chime When this option is set to Enabled, all the wireless keypads get active on
Chime, i.e. they wake up from the sleep mode in order to emit it. When this
option is set to Disabled, keypads do not wake up, and chime is not emitted.
Please note, that also other keypad settings can affect whether the acoustic
signal is actually emitted or not, for example, Keypad Features>Silent Keypad.
X-10 Address A menu entry that groups X-10 configuration options for IO modules.
Zone/User Selects the zone or user number necessary to trigger an output. If this location
is programmed as a zero (“0”), any zone or user will activate the output (see
also location 68).
The zone/user filter is active only for following events: Burglary Alarm, Fire
Alarm, 24h Alarm, Zone Tamper (it filters out zones for all these events), and
Code Entry (it filters out users). For all other events this setting is ignored.
To Next Page
Loading...
Need help?
General
