NetworX Version 3 Installation Manual
212
Reporting with partition modifiers
Partition modifiers are used to identify partitions. Events with partition modifiers are sent using the
syntax:
• >aaaaaa eennn[/Rin] [eennn[/Rin] …].
See
Table 30 for a detailed syntax description.
The settings and events in
Table 31 are transmitted in the following message.
• > 987654 BA001/Ri1 BA003/Ri1 YT000 TA030/Ri3.
SMS Contact ID reporting
Each SMS message contains only one event. The information in the message is the same as a Contact
ID message sent over the PSTN with the digits coded using ASCII instead of DTMF.
The following syntax is used
• aaaa18qnnnggppp
Table 32. Contact ID reporting syntax
Format key Description
aaaa Account number for the event that follows. Hexadecimal digits A - F are in upper case
18 Shows that this is a Contact ID message.
q Contact ID qualifier. '1' = activation, '3' = restore.
nnn Three-digit Contact ID event number (decimal).
gg
Two-digit group number (decimal). This contains the partition that generated the event, or zero
for a non-partition event
ppp Three-digit point number (decimal). This contains the zone, user or module number for the event.
0 Contact ID checksum. This ‘0’ can be ignored.
Example
The following example shows Partition 3 account code E9D3 has a keypad tamper (Contact ID 137)
on zone 30 partition 3.
• E9D318113703030
Table 33. Contact ID example
Part of Message Format key Description
E9D3 aaaaa Account number E9D3
18 18 Shows that this is a Contact ID message.
To Next Page
Loading...
Need help?
General
