GE NetworX V3 User Manual

NetworX Version 3 Installation Manual
49
Level 1 Level 2 Value State
Protocol Phone Number 1 SIA
Phone Number 2 SIA
Events Phone Number 1 – Alarms Enabled
Phone Number 1 – Alarm Restores Enabled
Phone Number 1 – Tampers and Restores Enabled
Phone Number 2 – Alarms Enabled
Phone Number 2 – Alarm Restores Enabled
Phone Number 2 – Tampers and Restores Enabled
Split reporting
Split reporting configures the control panel to report to two different central stations. Some events
must be reported to phone number 1 and others to phone number 2. The control panel dials the first
number twice. If it cannot reach this number, it dials the second number twice. It performs this
sequence for the number of times specified in Dial Attempts or until it reports the relevant event to
each number. The same account code is used to report to both numbers. Events for phone number 1
are enabled by default and events for phone numbers 2 are disabled by default.
Table 14. Split reporting
Level 1 Level 2 Value State
Phone Number Phone Number 1 123456
Phone Number 2 456789
Account Code Phone Number 1 BE5566
Phone Number 2 445566
Protocol Phone Number 1 SIA
Phone Number 2 SIA
Events Phone Number 1 – Alarms Enabled
Phone Number 1 – Alarm Restores Enabled
Phone Number 1 – Tampers Disabled
Phone Number 2 – Alarms Disabled
Phone Number 2 – Alarm Restores Disabled
Phone Number 2 – Tampers and
Restores
Enabled

GE NetworX V3 Specifications

General

Brand	GE
Model	NetworX V3
Category	Security System
Language	English