NetworX Version 3 Installation Manual
43
3. Do one of the following:
• Press ½ to toggle between insert mode and overwrite mode (insert mode allows you
to insert new numbers and overwrite mode allows you to overwrite existing numbers).
• Press ¾ to delete the number at the cursor position.
• Press #¾ to delete all the numbers from the number at the cursor position to the end
of the string.
4. Do one of the following:
• Press the keys 0 to 9 to insert new numbers.
• Press #0 to insert G (to use the GSM instead of the PSTN).
• Press #1 to insert a star.
• Press #2 to insert #.
• Press #3 to insert a four-second delay.
• Press #4 to insert P (this enables pulse dialing).
5. Press OK to accept the changes.
• If the new number is valid, the keypad beeps once to confirm the change and returns
to the menu option.
• If the new number is invalid, the keypad beeps three times to reject the change and
returns to the menu option.
6. Press NO to cancel the changes and return to the menu option.
Exiting the menu system
1. Press NO repeatedly until OK to Exit prompt displays.
Note: If you are not in a value selection mode nor in a value edit mode, you can press ## to display the OK to Exit
prompt. It also means you can exit any menu level immediately by pressing [NO] [#] [#].
2. Press OK at this prompt to exit the menu system.
After exiting the menu system all devices in the system are enrolled, and changed texts are sent to all
keypads in the system. When it happens, “Processing” and “Copying” messages are displayed
respectively on the keypads. It can take some time, especially in case of wireless keypads, and it is
always recommended to allow these processes to finish without entering anything on the keypad.
Editing text
Overview
The NetworX V3 has a text editor that includes a word library. You can use this editor to change the
text of certain programmable text options.
To Next Page
Loading...
Need help?
General
