GE NetworX V3 User Manual

NetworX Version 3 Installation Manual
225
GSM/GPRS module location-based programming
worksheets
In the table below, you can find all the data required for location-based programming. In order to
program the GSM/GPRS module, you should follow the procedure below:
1. Press OK to enter programming mode.
2. Next, type your installer code. At the OK=LOC prompt press OK. The “Enter the device
address” prompt displays. You are now in the program mode and ready to select the
module to program.
3. Press 78# to select the GSM/GPRS module.
4. Program the values from the table below.
5. When all the desired changes in programming have been made, quit programming mode
for the GPRS module by pressing twice the NO key. The NetworX V3 will exit
programming and return to the “Enter the device address” level. Pressing twice the NO
key again will exit the program mode.
Note: Each time you exit programming mode, the modem restarts and reads the PIN number, network operator and
SMSC address number from the NX-7002 configuration.
Table 35. NX-7002 programming worksheets
(Factory defaults are in bold italic text)
LOC DESCRIPTION DEFAULT PROGRAMMING DATA
MODE OF OPERATION FEATURE SELECTION
Segment 1 (Circle Numbers To Program) Segment 2 (Circle Numbers To Program)
1 Enable site initiated downloading
1 Use SIA DCS as backup format (Contact ID if off)
2 Enable remote initiated downloading
2 Reserved
3 Remote initiated download must be from
known source
3 Reserved
4 Enable remote download at test time 4 Reserved
5 Enable auto-answer incoming CSD GSM
download call
5 Reserved
6 Callback required for incoming CSD GSM
download call
6 Reserved
7 Use V.110 for site-initiated CSD GSM calls 7 Reserved
8 Use non-transparent mode for site
initiated CSD GSM calls
8 Reserved
Segment 3 (Circle Numbers To Program) Segment 4 (Circle Numbers To Program)
1 Reserved 1 Reserved
2 Polling enable (for UL AA) 2 Reserved
3 Reserved 3 Reserved
4 Reserved
4 TCP/IP Reporting in SIA (Contact ID if off)
5 Reserved 5 Reserved
6 Reserved 6 Reserved
7 Reserved
7 Use 3-DES encryption
0
8 Reserved
8 Up/downloading using GSM CSD (GSM GPRS if off)
1 DESTINATION SELECTION FOR REPORT
CONTROL 1
0
2 BACKUP DESTINATION SELECTION FOR REPORT
CONTROL 1
0

GE NetworX V3 Specifications

General

Brand	GE
Model	NetworX V3
Category	Security System
Language	English