NetworX Version 3 Installation Manual
224
Term Definition
Test Reports
A Reporting setting that sends a test report to the selected report control at pre-programmed
intervals. The units can be set in days or hours.
Traceability
A menu entry that groups additional information, like serial number, manufacture date, and firmware
revision.
Transparent mode
An operating mode for CSD on a GSM network. Data is transferred directly from one modem to
another modem.
Type An Options setting that displays the type of GSM modem used by the NX-7002.
U
U/D Authentication
Disable Time
An Up/Download setting that contains the length of time for which the system is disabled after the
maximum number of authentication attempts has been exceeded.
U/D Call Back after
Voice Call
An Up/Download setting that starts an up/download session after a voice call.
U/D Port An Options setting that indicates that configures the port for GPRS up/download.
Up/Download
A menu entry that groups options used to control download sessions between the up/download
software and the control panel.
Upload The process of retrieving information from a PC running the upload/download software.
Use V1.110
An Options setting that enables V.110 for site-initiated CSD GSM calls. Enable this setting if the PC is
on an ISDN line and is using an ISDN modem.
User ID
An Options setting that configures the user ID for a PAP login. Contact the network provider to
confirm if a PAP login is required and to obtain the user ID and password.
Using GSM Audio
An Options setting that indicates that the module is using GSM audio. The GSM audio channel is used
when the panel reports through the voice channel of the GSM network.
Using GSM CSD An Options setting that indicates that the module is using GSM CSD.
See also CSD
V
Version A menu option that displays the current software version of the GPRS module.
X
XSIA
Extended Securities Industry Association (reporting protocol). This adds a zone or user name when
appropriate to the report.
Z
Zone Bypass and
Restores
A Reporting setting that sends a report to the selected report control when a zone is bypassed. A
report is also sent when the zone is restored (un-bypassed).
Zone Inactivity
Monitor
A Reporting setting that sends a report to the selected report control when a zone inactivity event
occurs.
Zone Trouble and
Restores
A Reporting setting that sends a report to the selected report control when a zone trouble condition
occurs. A report is also sent when the trouble condition is no longer active.
To Next Page
Loading...
Need help?
General
