NetworX Version 3 Installation Manual
235
Chapter B7 Enrolling modules
Figure 27. Enrol menu
To enrol and default the system modules, you must enable the advanced menu. Select Maintenance
Mode>Advanced Menu>Enabled and press OK.
Enrolling the system modules
When you select the enrol modules process, new modules are enrolled on both the control panel and
the keypad. The keypad must enrol modules in order to display the relevant menu options.
1. Press OK at the system prompt and enter your installer code.
2. Navigate with the ½¾ keys to Enrol Modules>Enrol and press OK.
3. The keypad starts enrolling the modules. The Enrolling message is displayed while
enrolment is taking place (approximately 12 seconds). When the modules have been
enrolled, a beep sounds and the message disappears.
4. When the modules have been enrolled, the keypad returns to Enrol.
5. Verify the enrolled modules. Navigate with the ½¾ keys to Maintenance Mode and press
OK.
6. Scroll to Log Review and press OK. When the control panel enrols a module, it adds an
enrol event to the event log. This event contains the module number. Scroll through the
event log to verify that each module has been enrolled.
Note: The modules are enrolled each time you leave programming mode. In this case, the Enrolling message is
displayed but no beep sounds.
Note: Installer should enroll the system after adding or deleting NX devices. Not doing this can cause unexpected
messages or tamper alarms.
Defaulting the modules
Each module can be defaulted. It is recommended that you default each module before modifying its
settings.
1. Navigate with the ½¾ keys to Reset Settings in the relevant module menu and press OK.
In this case, select Control Panel>Reset Settings to restore the default control panel
settings.
2. A confirmation message is displayed. Press OK to accept the default settings.
3. The keypad sounder beeps once to confirm the reset.
1.1
Enrol
Number of Modules
1.2
To Next Page
Loading...
Need help?
General
