EasyManuals Logo
Home>GE>Medical Equipment>Venue R1

GE Venue R1 Service Manual

GE Venue R1
478 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
3-52 Section 3-6 - Configuration
PRELIMINARY
Section 3-9
Options Setup
3-9-1 Software Options
Most of the options for Venue™ are activated by installing a password (alphanumeric text string).
For installation instructions, see: Software Options Configuration on page 3 - 42.
3-9-2 USB Flash Card Setup
There is no special setup procedure for use of a USB Flash Card.
3-9-3 Wireless Network Adapter
The Wireless Network adaptor should be connected to the USB port located on the rear side of the
cockpit (monitor).
NOTE: It is possible to connect the Wireless Network adapter both when the system is powered ON, and after
it is powered OFF.
All software drivers for the Wireless Network are pre-installed for the designated Wireless Network
adaptor only.
IMPORTANT During Stand-by mode, it is NOT recommended to introduce or remove USB
devices; this may cause the system to lock-up during the boot-up procedure.
WARNINGWARNING
DO NOT ATTEMPT TO USE A DIFFERENT TYPE OF WIRELESS NETWORK ADAPTOR.
THE ULTRASOUND SYSTEM IS AN EXTREMELY SENSITIVE AND COMPLEX
MEDICAL SYSTEM. ANY UNAUTHORIZED PERIPHERALS MAY CAUSE SYSTEM
FAILURE OR DAMAGE!

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Venue R1 and is the answer not in the manual?

GE Venue R1 Specifications

General IconGeneral
BrandGE
ModelVenue R1
CategoryMedical Equipment
LanguageEnglish

Related product manuals