HIKVISION DS-2TD2637T-7/P User Manual

Cauon
●
Separate 4 vercal lines in the opcal-axis direcon at the close site, middle and far site
respecvely.
●
Separate 4 vercal lines at the le, middle and right of the image respecvely.
●
If manual
calibraon's result is incorrect, select another target to recalibrate.
●
Aer manual calibraon, refer to Verify the Calibraon Result to verify if the calibraon is
successful.
Result
Aer calibraon, the height and angle of camera will be shown in live view.
Verify the
Calibraon Result
The funcon can verify whether the calibrated value is consistent with the actual value.
Steps
1.
Click .
2.
Click
, and drag a vercal line in the view.
3.
Move the line to the target, then click to caculate the length.
Compare the calculated line length to the actual length to verify the
calibraon sengs.
4.
Click to exit.
Note
Verify not only person, but also other objects appeared in the view. Such as car, street lamp, etc.
7.3.5 Set Advanced Conguraon Parameters
Go to Conguraon → Perimeter Protecon → Advanced Conguraon and congure the
parameters.
Detecon Parameters
Single Alarm
The system only sends alarm once for one target triggering. Otherwise, the alarm will be
triggered
connuously unl the target disappears.
Restore Parameters
Restore Default
Click Restore to restore the parameters to the default.
Restart VCA
Click Restart to restart the VCA
funcon.
Thermal Opcal Bi-spectrum Network Camera User Manual
63

HIKVISION DS-2TD2637T-7/P Specifications

General

Brand	HIKVISION
Model	DS-2TD2637T-7/P
Category	Security Camera
Language	English