HIKVISION DS-2TD2637T-7/P User Manual

Steps
1.
Check Enable Auto Trigger.
2.
Set Trigger Time, and the device will trigger an alarm output to the alarm server automacally in
the set
me.
3.
Set Auto Trigger Delay. It refers to the me duraon that the alarm output remains in eect
aer
the auto trigger.
4.
Click Save.
9.2.2 FTP/NAS/Memory Card Uploading
If you have enabled and congured the FTP/NAS/memory card uploading, the device sends the
alarm
informaon to the FTP server, network aached storage and memory card when an alarm is
triggered.
Refer to Set FTP to set the FTP server.
Refer to
Set NAS for NAS conguraon.
Refer to Set Memory Card for memory card storage conguraon.
9.2.3 Send Email
Check Send Email, and the device sends an email to the designated addresses with alarm
informaon when an alarm event is detected.
For email
sengs, refer to Set Email .
Set Email
When the email is congured and Send Email is enabled as a linkage method, the device sends an
email
nocaon to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email funcon. Go to Conguraon → Network → Basic
Sengs → TCP/IP for DNS sengs.
Steps
1.
Go to email sengs page: Conguraon → Network → Advanced Sengs → Email .
2.
Set email parameters.
1) Input the sender's email
informaon, including the Sender's Address, SMTP Server, and
SMTP Port.
2)
Oponal: If your email server requires authencaon, check Authencaon and input your
user name and password to log in to the server.
3) Set the E-mail
Encrypon.
Thermal Opcal Bi-spectrum Network Camera User Manual
73

HIKVISION DS-2TD2637T-7/P Specifications

General

Brand	HIKVISION
Model	DS-2TD2637T-7/P
Category	Security Camera
Language	English