Medium
In this level, it
lters the complete forklift and all moving objects, such as a partially
covered but moving forklift in operation.
High
In this level, it lters the complete forklift, all moving objects, and still objects after
movement whose temperature are higher than the pre-alarm temperature.
Smoking Filter
Enable this function to
lter out high temperature alarms triggered by smoking.
Display Filtering Status
An OSD will be displayed when the function is enabled.
Restart Algorithm Library
Click Restart to restart the algorithm library of the corresponding lter function.
Note
●
The Smoking Filter and Forklift Filter vary according to different camera models.
●
Perimeter Protection, Smoke Detection and Forklift Filter are mutually exclusive.
5.
Click Save.
Set Normal Mode
This function is used to measure the temperature of the whole scene and alarm.
Steps
1.
Go to Conguration > Temperature Measurement & Fire Prevention > Basic Settings ,
and check Enable Temperature Measurement.
2.
Refer to
Set Thermography Parameters
to set the parameters.
3.
Go to
Conguration > Temperature Measurement & Fire Prevention > Advanced
Settings , and select Normal.
4.
Congure the parameters of normal mode.
Emissivity
Set the emissivity of your target. The emissivity of each object is different.
Distance
The distance between the target and the device.
Pre-Alarm Threshold and Filtering Time
When the temperature of target exceeds the Pre-Alarm Threshold and this status
lasts not shorter than the Filtering Time, the pre-alarm is triggered.
Alarm Threshold and Filtering Time
Thermal & Optical Bi-spectrum Network Camera User Manual
56
To Next Page
Loading...
Need help?
General
