When the temperature of target exceeds the Alarm Threshold, and this status lasts
not shorter than the Filtering Time, the alarm is triggered.
Pre-Alarm Output and Alarm Output
Check Pre-Alarm Output and Alarm Output to link the pre-alarm or alarm with the
connected alarm device.
Temperature Sudden Change Alarm
When the temperature change exceeds the set sudden change alarm value within the
set cycle, the camera triggers an alarm.
Note
Temperature sudden change alarm is only supported by certain device models.
5.
Refer to
Set Arming Schedule
for setting scheduled time. Refer to
Linkage Method
Settings
for setting linkage method.
6.
Optional: Set the offsite pre-alarm/alarm specially during off-hours when there are less
causes of false alarms. You can set the lower alarm threshold to improve the
efciency
of quick alarm.
Note
The function varies according to different camera models.
1)Check Enable Offsite.
2)Set the offsite pre-alarm/alarm and follow step 4~5 to adjust the pre-alarm/alarm
threshold and arming schedule during working hours.
Note
The same parameters and linkage method apply to the two kinds of pre-alarm/alarm,
only the threshold and arming schedule vary.
Offsite Pre-Alarm Threshold
When the temperature of target exceeds the Offsite Pre-Alarm Threshold during the
Offsite Arming Schedule, and this status lasts not shorter than the Filtering Time,
the pre-alarm is triggered.
Offsite Alarm Threshold
When the temperature of target exceeds the Offsite Alarm Threshold during the
Offsite Arming Schedule, and this status lasts not shorter than the Filtering Time,
the alarm is triggered.
Offsite Arming Schedule
Click and drag the time bar to select the arming off-hours for offsite pre-alarm and
alarm.
7.
Click Save.
The maximum and minimum temperature will be displayed on the live view.
Thermal & Optical Bi-spectrum Network Camera User Manual
57
To Next Page
Loading...
Need help?
General
