Version 1.1, 08/2013. Copyright 2012 Hitron Technologies
59
Version 1.1, 08/2013. Copyright 2013 Hitron Technologies
59
Hitron CGN3 User’s Guide
The following table describes the labels in this screen.
Table 19: The Basic: Port Triggering Screen
All Port Triggering Rules Use this field to turn port triggering on or off.
Select Enabled to turn port triggering on.
Select Disabled to turn port triggering off.
Port Triggering Rules
Select Select a port triggering rule’s radio button before clicking
Edit or Delete.
# This displays the arbitrary identification number
assigned to the port triggering rule.
Application Name This displays the arbitrary name you assigned to the
rule when you created it.
Trigger This displays the range of outgoing ports. When the
CGN3 detects activity (outgoing traffic) on these ports
from computers on the LAN, it automatically opens the
Target ports.
Target This displays the range of triggered ports. These ports
are opened automatically when the CGN3 detects
activity on the Trigger ports from computers on the
LAN.
Protocol This displays the protocol of the port triggering rule
(TCP, UDP or Both).
Timeout (ms) This displays the time (in milliseconds) after the CGN3
opens the Target ports that it should close them.
Twoway Status Usually a port triggering rule works for two IP
addresses; when a rule is enabled, other IPs will also be
allowed to use the rule as a trigger.
Status Use this field to turn the rule On or Off.
Add Click this to define a new port triggering rule. Port
triggering must first be set to Enabled. See Adding or
Editing a Port Triggering Rule on page 60 for
information on the screen that displays.
Edit Select a port triggering rule’s radio button and click this
to make changes to the rule. Port triggering must first be
set to Enabled. See Adding or Editing a Port Triggering
Rule on page 60 for information on the screen that
displays.
To Next Page
Loading...
Need help?
General
