Honda BF40D Owner's Manual

131
STORAGE
5. If there is water or contamination
mixed with the extracted gasoline,
proceed with the following steps.
5-a. Tighten the drain screw.
5-b. Set the outboard vertically and
connect to a fuel tank of clean
gasoline.
5-c. Sending the fresh gasoline to
the vapor separator thought the
priming valve, start the engine.
The propeller must be lowered into
the water, running the outboard
motor out of the water will damage
the water pump and overheat the
engine.
Operate the priming valve after
confirming the drain screw is
tightened. When the drain screw is
loose, gasoline will flow out.
5-d. After starting the engine, hold
in the idling position for 3
minutes.
5-e. Drain the gasoline from the
vapor separator.
5-f. Check that there is no water or
any contamination mixed with
the extracted gasoline.
5-g. If there is water or
contamination mixed with the
extracted gasoline, repeat from
step 5-a until there is nothing
mixed with the extracted
gasoline.
Vapor Separator Draining
Gasoline is extremely flammable,
and gasoline vapor can explode,
causing serious injury or death. Do
not smoke or allow flames or
sparks in your working area.
KEEP OUT OF REACH OF
CHILDREN.
• Be careful not to spill fuel.
Spilled fuel or fuel vapor may
ignite. If any fuel is spilled, make
sure the area is dry before
storing or transporting the
outboard motor.
• Do not smoke or allow flames or
sparks where fuel is drained or
stored.
<<DQQMࡍ࡯ࠫ㧞㧜㧝㧟ᐕ㧝㧜᦬㧝ᣣޓἫᦐᣣޓඦᓟ㧞ᤨ㧟㧡ಽ

Honda BF40D Specifications

General

Brand	Honda
Model	BF40D
Category	Outboard Motor
Language	English