Honda BF40D Owner's Manual

132
STORAGE
1. Disconnect the fuel line connector
(see page 101).
2. Remove the engine cover.
3. Release the drain tube from the
tube clamper of the high pressure
fuel pipe and bring the end of the
drain tube out of the engine under
case.
4. Loosen the vapor separator drain
screw.
5. Tilt up the outboard motor.
6. When the gasoline starts to flow
out of the drain tube, tilt down the
outboard motor and hold it in the
position until the gasoline stops
flowing.
Catch the draining gasoline in a
suitable container.
7. After draining, tighten the drain
screw and secure the drain tube to
the tube clamper of the high
pressure fuel pipe.
Before storing the outboard motor for
a prolonged period, we recommend
that you remove the fuel line
connector and operate the engine at
2,000 to 3,000 min
-1
(rpm) until it
stops.
Engine Oil
1. Change the engine oil (see pages
112 – 114).
2. Remove the spark plugs (see page
114), and remove the clip from the
emergency stop switch.
3. Pour a tablespoon or teaspoon (5 –
10 cm
3
) of clean engine oil into
each cylinder.
4. Rotate the engine a few revolutions
to distribute the oil in the cylinders.
5. Reinstall the spark plugs (see page
116).
DRAIN SCREW
VA P O R
SEPARATOR
TUBE CLAMPER
DRAIN TUBE
<<DQQMࡍ࡯ࠫ㧞㧜㧝㧟ᐕ㧝㧜᦬㧝ᣣޓἫᦐᣣޓඦᓟ㧞ᤨ㧟㧡ಽ

Honda BF40D Specifications

General

Brand	Honda
Model	BF40D
Category	Outboard Motor
Language	English