10-5
dummyheaddummyhead
STARTING SYSTEM
ASSEMBLY
Hook the outer hook [1] of the recoil starter spring [2] to
the groove [3] in the recoil starter reel [4], and install the
spring by winding it.
Check the recoil starter rope [1] and replace it if it is
frayed or worn.
Pass the rope through the hole [2] in the reel [3] and
then tie the rope as shown.
Wind the rope onto the reel 1-3/4 turns
counterclockwise as shown and hook it to the notch [4]
in the reel.
Pass the rope [1] through hole [2] of the recoil starter
case [3] and starter grip [4] and then tie the rope as
shown.
• Wear gloves and eye protection.
• During reassembly, take care not to allow the
spring to come out.
62Z7B000.book 5 ページ ２０１２年９月２７日 木曜日 午前１０時２１分
To Next Page
Loading...
Need help?
General
