Honda GX390H1 User Manual

14-27
dummyheaddummyhead
CRANKCASE
GX270H CRANKSHAFT OIL SEAL
REPLACEMENT (CYLINDER BARREL
SIDE)
CRANKSHAFT OIL SEAL (30 x 46 x 8
mm)
Remove the oil seal from the cylinder barrel.
Drive a new oil seal [1] in the position as shown using
the special tools.
Apply grease to the lip of a oil seal.
GX390H1 BALANCER WEIGHT
BEARING/GOVERNOR ARM SHAFT OIL
SEAL/CRANKSHAFT OIL SEAL
REPLACEMENT (CYLINDER BARREL
SIDE)
BALANCER WEIGHT BEARING (6202)
Pull out the radial ball bearing [1] using the special
tools.
Drive a new bearing [4] until it is fully seated on the end
using the special tools.
TOOLS:
Attachment, 45 x 50 mm [2] 07946-6920100
Driver handle [3] 07749-0010000
[2]
2.0 mm (0.08 in)
[3]
[1]
(Lips)
TOOLS:
Bearing remover shaft set,
15 mm [2] 07936-KC10500
Sliding hammer weight [3] 07741-0010201
TOOLS:
Attachment, 32 x 35 mm [5] 07746-0010100
Pilot, 15 mm [6] 07746-0040300
Driver handle [7] 07749-0010000
[2]
[7]
[3]
[1]
[4]
[6]
[5]
62Z7B000.book 27 ページ ２０１２年９月２７日 木曜日 午前１０時２１分

Honda GX390H1 Specifications

General

Brand	Honda
Model	GX390H1
Category	Engine
Language	English