Galaxy Flex Installer Manual Connect the battery and mains power
21
Connect the battery and mains power
The control panel can accommodate one 10 Ah or one 17 Ah battery, depending on version.
Ensure that the battery connector leads on the control panel are connected to the correct
terminals on the battery.
WARNING: There is a risk of explosion if the battery is replaced by an incorrect
type. Dispose of used batteries according to the instructions.
1. Connect the battery as shown:
Control panel Battery
−BAT −ve terminal
+BAT +ve terminal
2. Connect mains power to the panel.
Initial programming
For instructions on how to use the keypad see Keypad/KeyProx operation on page 218.
After power is applied, wait 1 minute and the keypad displays the message:
This is followed by the message:
PRESS ANY KEY
TO SET UP
Configuring
Please Wait
To Next Page
Loading...
Need help?
General
