To Next Page

To Previous Page

Omit Zones [11, Quick Menu 0] Galaxy Flex Installer Manual

Menu Options 11-19

Omit Zones [11, Quick Menu 0]

Use this option to remove (omit) zones from the system temporarily. Once a zone has been

omitted it does not generate an alarm condition (including tamper). Omitted zones are

reinstated automatically when the system is unset or reinstated manually when the zone omit

option is disabled.

On selecting the Omit Zones option, the first zone that has the omit attribute enabled is

displayed (refer to Program Zones [52]). If there are no omittable zones, then the message

NO ENTRIES is displayed.

Scroll to the zone you want to omit, and then press # to toggle the omit status. The display

indicates the new omit status.

Note: A zone is omitted from the system as soon as it is selected.

Repeat this process to omit more zones if required, and then do one of the following:

 press ent to start the timed setting routine. The number of zo

nes omitted from the

system is displayed during the exit time countdown;

 press esc to return to 11=OMIT ZONES without starting the setting routine.

On returning to the banner (normal or engineer) the keypad displays the message ZONES

OMITTED.

Outputs programmed as Zone Omit (mode programmed as reflex) are activated as soon as

the zone is omitted and remain active until the zone is reinstated.

Manually reintroduce omitted zones

Select the OMIT ZONES option.

Select the omitted zone to be reinstated, and then press # to toggle the omit status of the

required zone. The display indicates the new omit status.

Normal Setting with omitted zones

Initiate the full or part setting routine. The system starts to set, and the display indicates that

zones have been omitted. The zone remains omitted until the system is unset.

Timed Set [12]

This option starts the setting routine. The entry/exit horns emit the expiry warning using the

rogrammed exit time (0-300 seconds). The system sets at the end of the exit time or earlier

if a final zone is opened and closed, key 0 is pressed if programmed as an exit terminator, or

if a push-set terminator is operated. The option displays the time remaining until the system

sets or the number of open zones preventing the system from setting. Opening a zone during

the exit routine resets the exit timer. Pressing esc prior to the system setting aborts the

tting routine.

Honeywell Galaxy Flex V3 Series User Manual

Questions and Answers: