Summer [43, Quick Menu 8] Galaxy Flex Installer Manual
70
User Notify [42.4]
Use this option to send selected events to a maximum of three different mobile phone
numbers via SMS messaging. This can be configured either using the Telecoms module or
using the GSM module where fitted.
This function requires the appropriate SMS centre number to be programmed by the
installer.
Summer [43, Quick Menu 8]
European Daylight Savings Time (DST) is used, and is described as follows:
On the first day of each year, British Summer Time (BST) start date is set as the last Sunday
in March, and the end date is set as the last Sunday in October.
The operation of the Summer option is as follows: at 01:00 hours (GMT) on the start date,
the system clock advances to 02:00 hours (DST); at 02:00 hours (DST) on the end date, the
system clock goes back to 01:00 hours (GMT).
Note: The time always changes with reference to GMT. For example, Italy, which is +1
hour would be:
Last Sunday in March: 02.00 to 03.00
Last Sunday in October: 03.00 to 02.00
The start and end dates can be reprogrammed by authorized user codes. Press A to modify
th
e start date, or press the B key to modify the end date.
The new date must be a valid four-digit number, in the day/month (dd/mm) format.
Trace [44]
This option records:
the most recent alarm activation.
details of system setting and unsetting immediately before and after the alarm
activation.
the first five events occurring during the alarm activation.
This information is maintained in the trace until the next alarm activation.
Press # while viewing the Trace option to display additional information about certain
events. User events reveal the keypad, user level and current group; alarm events reveal the
zone descriptor if programmed.
To print the currently displayed trace, press
.
To abort the printout, press esc.
Note: A printer must be connected to the panel via a printer interface module.
Group Mode
If group mode is enabled (refer to Group Mode [63.1]), there is a separate trace for the
most recent alarm activation in each of the groups. On selecting the Trace option, a user
with group choice (refer to Codes [42]) can view the trace of the assigning groups.
To Next Page
Loading...
Need help?
General
