98 Xenon XP User Guide
Character Activation Timeout
You can set a timeout for the length of time the illumination remains on and
attempting to decode barcodes when using Character Activation Mode. Set the
length (in milliseconds) for a timeout by scanning the following barcode, then
setting the timeout (from 1-300,000 milliseconds) by scanning digits from the
Programming Chart, beginning on page 311, then Save. Default = 30,000 ms.
Character Deactivation
If you have sent a character from the host to trigger the scanner to begin scanning,
you can also send a deactivation character to stop scanning. Scan the following On
barcode to use character deactivation, then use Deactivation Character
(following) to select the character you will send from the host to terminate
scanning. Default = Off.
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the ASCII Conversion Chart (Code Page 1252), page 300,
find the hex value that represents the character you want to use to terminate
scanning. Scan the following barcode, then use the Programming Chart, beginning
on page 311 to read the alphanumeric combination that represents that ASCII
character. Scan Save to finish. Default = 14 [DC4].
End Character Activation After
Good Read
Character Activation Timeout
To Next Page
Loading...
Need help?
General
Weight and Dimensions
