52 Xenon XP User Guide
Interval Between Alerts
If you have set the Low Power Alert Repeat (page 51) to more than 1, you can set
the length of time, in seconds, between the low power alerts. To set this interval,
scan the barcode below and then scan a digit (10-120) barcode from the
Programming Chart, beginning on page 311, then Save. Default = 10 seconds
between alerts.
Low Power Alert Beep
If you do not want the beeper to sound for a low power alert, scan the Low Power
Alert Beep Off barcode. Any low power alert settings will still flash the scanner
LEDs, whether or not the beeper sounds. Default = Low Power Alert Beep On.
Reset Scanner
Scanning this barcode reboots the scanner and causes it to relink with the base or
Access Point.
Scan While in Base Cradle
If you want to be able to scan barcodes while the scanner is in the base cradle, scan
the Scan in Cradle On barcode below. If you want to only allow scanning when the
scanner is out of the base cradle, scan Scan in Cradle Off. If you want the scanner
To Next Page
Loading...
Need help?
General
Weight and Dimensions
