Honeywell Xenon XP 1952g User Manual

Xenon XP User Guide 201
Digimarc Barcode™
Digimarc Decoder Attempts
Set the number of attempts by scanning the barcode below, then setting the
number of attempts (0-10) by scanning digits from the Programming Chart
beginning on page 311 of this manual, the Save. Minimum to Maximum attempts =
0-10. Default = 3.
Digimarc Barcode
This setting programs the scanner to decode Digimarc Barcode using Digimarc
and ID decoders. When Digimarc Barcode is set to On, the Digimarc decoder is
used on most frames and the ID decoder will read every fifth frame.
When Digimarc Barcode is set to Uses ID Decoder then Both Decoders, the ID
decoder will read the number of attempts set by the Digimarc Decoder Attempts
and then will use both ID and Digimarc decoders. When Digimarc Barcode is set to
Uses Digimarc Decoder then Both Decoders, the Digimarc decoder will read the
number of attempts set by the Digimarc Decoder Attempts and then will use both
ID and Digimarc decoders.
When Digimarc Barcdoe is set to Uses ID Decoder then Alternates Decoders, the
ID decoder will read the number of attempts set by the Digimarc Decoder Attempts
and then will alternate between ID and Digimarc decoders. When Digimarc
Barcode is set to Uses Digimarc Decoder then Alternates Decoders, the Digimarc
decoder will read the number of attempts set by the Digimarc Decoder Attempts
and then will alternate between ID and Digimarc decoders.
Default = Uses Digimarc Decoder then Both Decoders.
Digimarc Decoder Attempts
Off
On
Uses ID Decoder then Both
Decoders

Honeywell Xenon XP 1952g Specifications

General

Type	Handheld bar code reader
Sensor type	-
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	Code 128, Code 39, U.P.C.
Optical sensor resolution (W x H)	1240 x 800 pixels
2D (matrix & stacked) barcodes supported	Data Matrix, PDF417, QR Code
Battery life	14 h
Charging time	4.5 h
Battery capacity	2400 mAh
Power source type	Battery
Number of reads per charge	50000
Wireless range	10 m
Bluetooth version	4.2
Operating frequency	2400 MHz
Standard interfaces	Bluetooth, USB
Connectivity technology	Wired & Wireless
Product color	Black
LED indicators	Yes
Built-in display	No
Protection features	Bump resistant
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	99 mm
Width	64 mm
Height	165 mm
Weight	220 g