Xenon XP User Guide 125
DATA EDIT
Prefix/Suffix Overview
When a barcode is scanned, additional information is sent to the host computer
along with the barcode data. This group of barcode data and additional,
user-defined data is called a “message string.” The selections in this section are
used to build the user-defined data into the message string.
Prefix and Suffix characters are data characters that can be sent before and after
scanned data. You can specify if they should be sent with all symbologies, or only
with specific symbologies. The following illustration shows the breakdown of a
message string:
Points to Keep In Mind
• It is not necessary to build a message string. The selections in this chapter are
only used if you wish to alter the default settings. Default prefix = None. Default
suffix = None.
• A prefix or suffix may be added or cleared from one symbology or all
symbologies.
• You can add any prefix or suffix from the ASCII Conversion Chart (Code Page
1252), beginning on page 300, plus Code I.D. and AIM I.D.
• You can string together several entries for several symbologies at one time.
Prefix
Scanned Data
Suffix
1-11 alpha
numeric &
control
characters
variable
length
1-11 alpha
numeric &
control
characters
To Next Page
Loading...
Need help?
General
Weight and Dimensions
