EasyManuals Logo
Home>HP>Switch>3600 v2 Series

HP 3600 v2 Series Security Configuration Guide

HP 3600 v2 Series
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #219 background imageLoading...
Page #219 background image
208
Configuring secure MAC addresses
Secure MAC addresses are configured or learned in autoLearn mode and can survive link down/up
events. You can bind a secure MAC address to only one port in a VLAN.
Secure MAC addresses fall into static, sticky and dynamic secure MAC addresses.
Table 11 A comparison of static, sticky, and dynamic secure MAC addresses
Type Address sources Aging mechanism
Can be saved and
survive a device
reboot?
Static Manually added
Not available.
They never age out unless you manually remove
them, change the port security mode, or disable
the port security feature.
Yes.
Sticky
Manually added or
automatically learned
when the dynamic
secure MAC function
is disabled.
They do not age out by default, but you can
configure the following aging functions:
• Aging timer—A sticky MAC address ages
out when its aging timer expires, but whether
it is immediately deleted depends on the
aging delay setting.
• Aging delay—If aging delay is disabled, the
system deletes the sticky MAC address
immediately after the aging timer expires. If
aging delay is enabled, the system deletes
the sticky MAC address if no data traffic is
from the secure source MAC address before
the delay expires.
Yes.
The secure MAC aging
timer restarts at a
reboot.
Dynamic
Converted from sticky
MAC addresses or
automatically learned
after the dynamic
secure MAC function
is enabled.
Same as sticky MAC addresses.
No.
All dynamic secure
MAC addresses are
lost at reboot.
IMPORTANT:
W
hen the maximum number of secure MAC address entries is reached, the port chan
g
es to secure mode,
and no more secure MAC addresses can be added or learned. The port allows only frames sourced from
a secure MAC address or a MAC address configured by using the mac-address dynamic or mac-address
static command to pass through.
Configuration prerequisites
• Enable port security.
• Set port security’s limit on the number of MAC addresses on the port. Perform this task before you
enable autoLearn mode.
• Set the port security mode to autoLearn.

Table of Contents

Other manuals for HP 3600 v2 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 3600 v2 Series and is the answer not in the manual?

HP 3600 v2 Series Specifications

General IconGeneral
BrandHP
Model3600 v2 Series
CategorySwitch
LanguageEnglish

Related product manuals