To Next Page

To Previous Page

161

# Configure dm1 as the default ISP domain for all users. Then, if a user enters the username without the

ISP domain at logon, the authentication and accounting methods of the default domain are used for the

user.

[Switch] domain default enable dm1

• Configure portal authentication

# Configure a portal server on the switch, making sure that the IP address, port number and URL match

those of the actual portal server.

[Switch] portal server newpt ip 192.168.0.111 key portal port 50100 url

http://192.168.0.111:8080/portal

# Enable portal authentication on the interface connecting the host.

[Switch] interface vlan-interface 100

[Switch–Vlan-interface100] portal server newpt method direct

[Switch–Vlan-interface100] quit

Configuring re-DHCP portal authentication

Network requirements

As shown in Figure 67:

• The host is directly connected to the switch and the switch is configured for re-DHCP authentication.

The host is assigned with an IP address through the DHCP server. Before passing portal

authentication, the host uses an assigned private IP address. After passing portal authentication, the

host can get a public IP address and access Internet resources.

• A RADIUS server serves as the authentication/accounting server.

Figure 67 Network diagram

Configuration procedure

HP 3600 v2 Series Security Configuration Guide

Other manuals for HP 3600 v2 Series