Chapter 1 Installation Overview
2
Remove the Cover
If you are installing options, you will need to remove the cover. To install options,
you will need a flat 1/4-inch screwdriver and T15 TORX® driver; you do not need
tools to remove the cover
WARNING Before removing the cover, always disconnect the power cord
and unplug telephone cables. Disconnect the power cord to
avoid exposure to high energy levels that may cause burns
when parts are short-circuited by metal objects such as tools or
jewelry. Disconnect telephone cables to avoid exposure to
shock hazard from telephone ringing voltages.
To remove the cover:
1. Turn off the NetServer and disconnect the power cord.
2. Unlock the cover: To unlock the cover, use the key in the key bag located
on the rear of the NetServer.
3. Release the latches: Lift up the two release latches on the sides of the front
bezel.
4. Remove the cover. Place your hands on the top of the cover, one along
each edge (see figure, below). While applying downward pressure, pull the
cover sharply forward to release it and then slide it forward and off the
NetServer.
5. Remove the air cooling duct. Lift up on the front of the duct until the T-
hook is free of the slot, as shown below. Then gently pull the duct towards
the front of the NetServer and lift it up and out of the chassis. Store it in a
safe place; you must replace it before you replace the cover.
To Next Page
Loading...
Need help?
General