Chapter 3
15
3. From Program Manager, select the File menu and choose Run.
4. At the command prompt, type the following:
drive: \infoasst\setup /a
where drive is the letter of the CD-ROM drive.
5. Follow the instructions that appear on your screen.
Running the Setup Program on a Client PC
To run the HP NetServer Information Assistant from a client PC, it is necessary
for the client to run the setup program that was installed onto the network hard
disk, as follows:
1. Run Windows and display the Program Manager.
2. From Program Manager, select the File menu and choose Run.
3. At he command prompt, type the network location where the HP NetServer
Information Assistant files were installed, followed by setup.
For example, if Information Assistant was installed on drive “N:
\windows\iaclient,” you would enter the following:
N: \windows\iaclient\setup
4. Follow the instructions that appear on your screen.
Server Management Using HP Support Anywhere
Built-in hardware and software attributes of the HP NetServer E 40 allow for
different ways of remotely monitoring and controlling your NetServer. You can
use HP Support Anywhere to get timely information about your network servers
and find out immediately when a server is experiencing problems. In addition,
Support Anywhere notifies you when a NetServer is likely to have problems in the
near future.
Support Anywhere can handle multiple network operating systems (NOS) and
supports NetServers running either Novell NetWare / IntranetWare or Microsoft
Windows NT.
Any or all of the following Support Anywhere features can be used to manage
your NetServer(s) in a networking environment. Support Anywhere management
tools include the following:
• Auto Alert provides prompt notification of server operations
To Next Page
Loading...
Need help?
General