Chapter 6
43
1. Restart the NetServer.
2. During the boot process, press [F2] to start the Setup program.
3. Enter the Administrator password then access the Setup program menu.
4. From the User Password menu, select "Set User Password" option.
5. Set the User password. Enter the Administrator password as the old
password. (This will replace the old, forgotten password).
6. Choose the Exit option and save the changes to save the new password.
Administrator Password
If you have forgotten the Administrator password, your NetServer will function
normally, but you will not be able to change the system configuration settings
(including User password) in the Setup program. To reset the Administrator
password:
1. Switch off the NetServer.
2. Remove the cover and the cooling duct.
3. Move the switch on the system board labeled "Clear Password" to the
closed position.
4. Switch on the NetServer and allow it to complete its startup routine. The
old passwords (both User and Administrator) will be erased.
5. Switch off the NetServer.
6. Return the switch on the system board labeled "Clear Password" to the
open position.
7. Replace the cooling duct and the cover.
8. Switch on the NetServer and allow it to complete its startup routine.
9. If you wish to set passwords again, after the power-on system hardware test
has completed, press [F2] to start the Setup program.
10. Set the new password(s).
11. Choose the Exit option and save the changes to save the new password(s).
Battery Problems
If your HP NetServer repeatedly loses its configuration or the CPU clock stops,
you should replace the battery or install an external battery (an external battery
To Next Page
Loading...
Need help?
General