To Next Page

To Previous Page

Chapter 4

Installing UPS Software

To install the UPS Software, follow these steps:

1. Insert the HP NetServer Navigator CD-ROM into the CD-ROM drive

that is accessible from the Windows client.

2. In the Windows Program Manager, select Run from the File

drop-down menu.

3. At the Command Line prompt, type the following:

drive: \PWA\NETWARE\DISK1\SETUP.EXE

where drive is the letter of the CD-ROM drive.

4. Follow the instructions on the screen.

◊ You will be prompted to identify an installation path for the software.

◊ In the Installation Options window, select PowerWise Assistant.

◊ You will need to identify the server as a Master or a Slave. For the

Master server, you must identify the port on the server to which the HP

PowerWise UPS is connected. For a Slave server, you must provide the

name of the Master.

5. Depending on your installation choices, one or more of the following

commands are added to the AUTOEXEC.NCF file:

load aiocomx

load hpups

load hpslave

load hpupscag

load hpupssd

Either reboot the server to load these files, or manually load them by

entering pwaload at the server console.

To Install the User Interface on a Local Client PC

Optionally, you can install the HP PowerWise user interface on an additional local

client PC that you will be using to manage the HP PowerWise UPS.