Chapter 4 Installing UPS Software
24
UPS Installation for Novell NetWare / IntranetWare
NOTE Refer to the README file located in the \pwa\netware\disk1
directory on the Navigator CD-ROM for any updates to the
installation procedure.
If you do not have a client with Windows (version 3.1 or later)
to manage the HP PowerWise UPS, refer to the README file
located in the \pwa\netware\dos directory on the Navigator
CD-ROM for the installation procedure.
Before installing the software, make sure that:
• Your HP PowerWise UPS is plugged in, turned on, and connected to the
server via the serial cable. (See the instructions in the road map for your
E Series NetServer).
• Novell NetWare is running on your HP NetServer. You must have
supervisor or administrator capabilities to install this software.
• You have unloaded any earlier versions of HP PowerWise Assistant, and
removed it from the AUTOEXEC.NCF file. Refer to the UPS README
file for details.
If you are using HP OpenView for Windows to manage your HP PowerWise UPS,
make sure that:
• HP OpenView for Windows is installed on your central management
console
• SNMP services are installed and properly set up
• (Optional) HP Support Anywhere is installed on your server and central
management console, if you are using it to manage the server
To Install the UPS Software on the HP NetServer
Install the HP PowerWise Assistant application on the HP NetServer to which the
UPS is connected and on a local Windows client used to manage the server. With
Novell NetWare / IntranetWare, you can have more than one server connected to a
UPS. The server to which the UPS is connected via the serial cable is the “Master”
server. Other servers powered by the UPS are “Slave” servers.
To Next Page
Loading...
Need help?
General