HP FlexNetwork MSR 954 User Manual

54
Figure 20 Network diagram
Configuration procedure
1. Assign an IP address and subnet mask for each interface, as shown in Figure 20. (Details not
shown.)
2. Configure OSPF on Router B and Router C. (Details not shown.)
3. Enable IP multicast routing, and enable IGMP and PIM-DM:
# On Router C, enable IP multicast routing.
<RouterC> system-view
[RouterC] multicast routing
[RouterC-mrib] quit
# Enable IGMP on the receiver-side interface (GigabitEthernet 1/0/1).
[RouterC] interface gigabitethernet 1/0/1
[RouterC-GigabitEthernet1/0/1] igmp enable
[RouterC-GigabitEthernet1/0/1] quit
# Enable PIM-DM on GigabitEthernet 1/0/2.
[RouterC] interface gigabitethernet 1/0/2
[RouterC-GigabitEthernet1/0/2] pim dm
[RouterC-GigabitEthernet1/0/2] quit
# On Router A, enable IP multicast routing.
<RouterA> system-view
[RouterA] multicast routing
[RouterA-mrib] quit
# Enable PIM-DM on each interface.
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim dm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim dm
[RouterA-GigabitEthernet1/0/2] quit
# Enable IP multicast routing and PIM-DM on Router B in the same way Router A is configured.
(Details not shown.)
4. Display RPF information for Source 2 on Router B and Router C.
Router A Router B Router C
GE1/0/2
30.1.1.2/24
GE1/0/2
20.1.1.2/24
GE1/0/2
20.1.1.1/24
GE1/0/3
30.1.1.1/24
Source 1Source 2 Receiver
40.1.1.100/24 10.1.1.100/24
Multicast static route
GE1/0/1
40.1.1.1/24
GE1/0/1
10.1.1.1/24
OSPF domain
PIM-DM
50.1.1.100/24
GE1/0/1
50.1.1.1/24

HP FlexNetwork MSR 954 Specifications

General

Brand	HP
Model	FlexNetwork MSR 954
Category	Network Router
Language	English