HP ProLiant ML30 Gen10 Plus User Manual

HPE Smart Storage Hybrid CapacitorHPE Smart Storage Hybrid Capacitor
The HPE Smart Storage Hybrid Capacitor supports the following devices:
HPE SR controllers
The capacitor pack can support up to two devices.
This server supports the HPE Smart Storage Hybrid Capacitor with the 145 mm cable.
Before installing the HPE Smart Storage Hybrid Capacitor, verify that the system BIOS meets the minimum firmware requirements to
support the capacitor pack.
IMPORTANT:IMPORTANT:
If the system BIOS or controller firmware is older than the minimum recommended firmware versions, the capacitor
pack will only support one device.
The capacitor pack is fully charged after the system boots.
HPE Smart Storage Hybrid Capacitor 126

HP ProLiant ML30 Gen10 Plus Specifications

General

Processor Sockets	1
Memory	Up to 128 GB DDR4 ECC UDIMM
Memory Slots	4
Form Factor	Tower
Processor	Intel Xeon E-2300 series
Storage	Up to 4 LFF or 8 SFF drives
RAID Support	HPE Smart Array S100i, S100i SR Gen10 SW RAID
Network	1 x 1GbE
Power Supply	350W
Chipset	Intel C252
Storage Controller	HPE Smart Array S100i, S100i SR Gen10 SW RAID
Maximum Internal Storage	Up to 64 TB
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Weight	Approx. 10.5 kg