HP ProLiant ML30 Gen10 Plus User Manual

Install the server into the rackInstall the server into the rack
PrerequisitesPrerequisites
Before you perform this procedure, review the:
Rack warnings and cautions
Server warnings and cautions
Make sure that the PCI fan is installed .
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Grasp the tray notch to slide the tray out of the rack.
2. Place the server on the tray.
Verify that the front panel of the server is align with the front of the tray.
Install the server into the rack 50

HP ProLiant ML30 Gen10 Plus Specifications

General

Processor Sockets	1
Memory	Up to 128 GB DDR4 ECC UDIMM
Memory Slots	4
Form Factor	Tower
Processor	Intel Xeon E-2300 series
Storage	Up to 4 LFF or 8 SFF drives
RAID Support	HPE Smart Array S100i, S100i SR Gen10 SW RAID
Network	1 x 1GbE
Power Supply	350W
Chipset	Intel C252
Storage Controller	HPE Smart Array S100i, S100i SR Gen10 SW RAID
Maximum Internal Storage	Up to 64 TB
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Weight	Approx. 10.5 kg