The sign is inserted into the sign position as specified in the Edit Option file. When the sign position
is specified as “unsigned,” no minus sign is inserted for negative values (indicated by sign bits B or
D).
Figure 47 Conversion When “Leading sign” is Specified
.
Figure 48 Conversion When “Trailing sign” is Specified
.
Figure 49 Conversion When “Insert sign before effective digits” is Specified
.
Figure 50 Conversion When “Unsign ed” is Specified
.
Zero Suppression
Zero suppression replaces leading zeroes preceding the effective digits in the output field to spaces.
Zero suppression is performed according to the option specified in the Edit Option file. Zeroes are
suppressed in relation to sign position, as shown in the examples that follow.
Figure 51 Conversion When “No zero suppression”, “Leading sign” is Specified
.
Figure 52 Conversion When “Zero suppression”, “Trailing sign” is Specified
.
Decimal Point
A decimal point is inserted according to the number of decimal places specified in the Edit Option
file. When 0 is specified, there will be no decimal point, and no decimal point is inserted.
Numeric Conversion66
To Next Page
Loading...
Need help?
General