– 6 –
PROGRAMMING MODE OVERVIEW
In programming mode, you can set a variety
of functions, from joining a shade to a Group
to removing a shade from a Group, to setting
Favourite shade positions. You must activate
programming mode on the PowerView™ Pebble
®
Remote to establish communication between the
remote and shade.
ENTER PROGRAMMING MODE
q
PRESS and HOLD (Stop) for 6 seconds
until indicator lights blink on the PowerView
Pebble Remote.
w
RELEASE (Stop).
NOTE: Indicator lights on the remote will
continue blinking for 20 seconds following
each set of commands allowing additional
shades to be programmed, if desired.
EXIT PROGRAMMING MODE
q
To EXIT programming mode, PRESS and
HOLD
(Stop) until the indicator light
stops blinking.
w
RELEASE (Stop).
NOTE: If no buttons are pressed on the
remote for 20 seconds, the remote will exit
programming mode. All settings performed
while in programming mode will be retained.
4
VIDEO INSTRUCTION
q w
To Next Page
Loading...
Need help?
General