English - 41
2. SPECIAL MENU FUNCTIONS
2.7.5 Loop detection (5-5)
This function makes it possible to temporarily switch
off a mower’s loop detection, i.e. to be able to run it
without the charging station and boundary wire being
installed. Such times include demonstrating an
Automower at the home of a customer.
The checkbox is checked when ON is selected. ON
means the Automower can only work when there is a
loop signal.
The function is switched off automatically when the
mower is switched off and on using the main switch.
NOTE!
Remember to reactive loop detection again.
2.7.6 Special settings (5-6)
Square mode cutting (5-6-1)
The preset value for square mode cutting is 70 %
(50 % for 220 AC and Solar Hybrid). The value can
be changed in exceptional cases, when an
Automower seems to use square mode cutting
frequently or infrequently. The higher the value, the
more infrequently Automower will carry out square
mode cutting and vice versa. See page 12 for more
information about square mode cutting.
To change the entry level: Select Square cutting and
then place the cursor on Input value and press YES.
It is also possible to switch the square cutting function
off completely. However, this should only be done in
exceptional cases. To switch off square cutting:
Select the function OFF and press YES. Place the
cursor on OFF and press YES again.
Reset square cutting is used to reset the time counter
for square mode cutting. An Automower must run
uninterrupted (mowing + charging) for about 13 – 14
hours before it can start square mode cutting. This
function is used, for example, if you wish to prevent
square mode cutting when the mower is moved from a
well-mown area to an unmown area. Select the
function and press YES when the cursor is on Yes to
reset.
New startup sequence (5-6-2)
This function can be used when a second-hand
Automower is sold. The new owner will then be asked
the start-up questions about language, date, and time
when the main switch is turned ON for the first time. In
addition, all settings on the Automower will be restored
to their original values, see Table 4: Factory settings,
page 42.
Operating history
Test
Live data
Demo mode
Loop detection
Special settings
5-5
ON
OFF
5-5-
Operating history
Test
Live data
Demo mode
Loop detection
Special settings
5-6
Square mode cutt.
New start. sequence
Calibrate tilt sensor
STOP button
override
5-6-
To Next Page
Loading...
Need help?
General
