46 - English
3. INSTALLATION
3.3 Guide wire
This section only applies to 220 AC, 230 ACX and
Solar Hybrid.
3.3.1 Need of a guide wire
With the help of a guide wire Automower can quickly
and easily find the charging station by following the
guide wire instead of searching irregularly or by
following the boundary wire.
On 230 ACX and Solar Hybrid it is possible to install
two guide wires, examples showing installation with
two guide wires can be found in chapter 3.10
Installation examples, page 54.
When any of the following can be found in the working
area, the installation of a guide wire is recommended.
• Narrow passages.
In passages where the distance between the
boundary wires is less than 3 metres (10 ft), it is
recommended to install a guide wire through the
passage. This is a better solution than allowing
Automower to follow close to the boundary wire by
setting a low Corridor width value.
• The boundary wire runs along a steep slope
(steeper than 35 %).
When Automower follows the boundary wire that
runs along a steep slope, the mower will change
direction and run away from the boundary wire.
• Numerous or large islands.
If Automower is permitted to follow the boundary
wire it may circle an island roughly twice before it
leaves the island and once again searches for
the boundary wire.
• The route to a remote area is long or
complicated.
When Automower shall follow the boundary wire
to or from a remote area and the route along the
boundary wire to the area is long or complicated.
To Next Page
Loading...
Need help?
General
