62 - English
4. AUTOCHECK, SERVICE PROGRAM
4. Autocheck, Service program
The service program Autocheck is a tool to help trouble
shoot as well as send and retrieve information to/from
an Husqvarna Automower™. You can also, via
Autocheck, update the mower program in an
Automower.
Autocheck is intended for Automower models from
2003. The program does not work on earlier models.
This technical manual deals with Autocheck
version 6.0.
The mower is connected to the computer via a service
cable. There are two cables available, one for the COM
port (part number 535 13 24-01) and one for the USB
port (part number 535 13 23-02). It is also possible to
connect 535 13 24-01 to a USB port through a virtual
COM port. The virtual COM port can also be used for
the service cable to Automower generation 1. Virtual
COM-port, also known as a USB-adapter, can be
ordered and has the part number
544 08 50-01Installation of Autocheck.
4.1 Installation of Autocheck
Autocheck can only be installed on PC-computers.
Installing Autocheck
1. Exit all open programs on your computer.
2. Insert the CD with the service program into the
computer's reader.
The disc normally starts automatically, if this does
not happen you will need to open it manually via
My computer or Explorer.
3. Follow the onscreen instructions.
When the installation has finished an Autocheck menu
will be created in the Start menu on your computer. A
shortcut is also automatically created on the
computer's desktop.
To Next Page
Loading...
Need help?
General
