Husqvarna AUTOMOWER 230 ACX Technical Manual

84 - English
5. REPAIR INSTRUCTIONS
5. Repair instructions
All repairs to the Husqvarna Automower™ should be
made indoors on a clean work bench to protect
sensitive components from moisture and dirt.
All components on the Automower must be fitted
according to the values in Table 7: Tightening Torques,
page 100.
IMPORTANT INFORMATION
Oil, grease and dirt on electrical contactors
can cause intermittent faults on the
Automower. These faults only occur at times,
which makes them difficult to find. Never
touch sensitive electronic components with
your fingers, for example, connector pins or
components on a circuit card.
Ground yourself, for example against a
radiator or on the mower’s chassis, before
you start to work on electrical components.
When you disconnect a cable from a
component: Always pull the connector and
NOT the cable.
Never use any form of silicone or the like
when repairing an Automower.
If possible check that replaced components
work before completing the assembly of
Automower.

Husqvarna AUTOMOWER 230 ACX Specifications

General

Cutting Width	22 cm
Cutting Height (min-max)	20-60 mm
Battery Type	NiMH
Area Capacity	3000 m²
Maximum Incline	35%
Power Consumption During Cutting	30 W
Cutting System	3 pivoting razor blades
Alarm	Yes
PIN Code	Yes
Lift Sensor	Yes
Tilt Sensor	Yes
Typical Mowing Time on One Charge	60 minutes
Typical Charging Time	60-80 minutes