Installing Windows 95 Software
To install the MPEG device driver, proceed to the following section.
Installing the MPEG Device Driver for Windows 95
The MPEG device driver enables playback for MPEG motion video,
CD-i movies, and Video CDs on your computer. To install the MPEG
driver for Windows 95:
1
Start Windows 95; then click on My Computer.
2
Click on Control Panel and then Add New Hardware.
3
Click on Next> ; then select No to the question Search for your
new hardware?
4
Click on Next> ; then select Sound, video and game
controller.
5
Click on Next> .
6
Insert the MPEG Features Diskette for Windows 95 into the
diskette drive; then click on Have Disk....
7
Highlight IBM MPEG CD-i/VideoCD (mci) ; then click on OK.
8
Click on OK; then click on Finish.
9
Click on Finish.
10
When Windows 95 prompts you to restart the computer, click
on No, and repeat steps 2 to 9 to install IBM MPEG
Files/ISO9660 (mci), by selecting IBM MPEG Files/ISO9660
(mci) in step 7.
11
When Windows 95 prompts you to restart the computer, click
on No, and repeat steps 2 to 9 to install IBM MPEG PCI Bridge
by selecting IBM MPEG PCI Bridge in step 7.
If this is the first installation of the IBM MPEG PCI Bridge, you
must do the following once. This procedure removes the device
from the unknown class and adds it to the sound, video, and
game controllers.
a) Select Control Panel, System, and then Device Manager.
b) Select Other Devices and PCI Multimedia Device.
c) Select Remove; then click on OK.
12
Shut down Windows 95 and restart the computer.
Chapter 7. Installing Software 213
To Next Page
Loading...
Need help?
General
