IBM THINKPAD S05L-1270-01 Instruction Manual

Advanced Information for PC Cards
specified, no extra drive is given to the device driver. The
extra drives can be activated by the PCMCIA ATA Card
Mount utility.
/!DM Specifies not to use OS2DASD.DMD as the device
manager. When this parameter is set, OS2PCARD.DMD is
used instead.
Parameters for DOS PCMCIA Storage Card Device Drivers
DOS
The following are the parameters in the DOS PCMCIA storage card device
driver and their explanations:
DEVICE=[drive:] [directory] PAWATA.SYS [/P:hhhh] [/NOBEEP]
[/STBTIME:n][/MDRV:n]
DEVICE=[drive:] [directory] PAWATAS.SYS [/P:hhhh] [/NOBEEP]
[/STBTIME:n][/MDRV:n]
DEVICE=[drive:] [directory] PAWATASF.SYS [/P:hhhh]
[/NOBEEP] [/STBTIME:n] [/MDRV:n] [/EMS] [/TSIZE:n]
/P:
hhhh Specifies the lower limit for the I/O address of the ATA
card. The device driver assigns the next usable I/O
address from this lower limit to the card. When this
parameter is not set, the device driver looks for a usable
address and assigns that address to the card.
/NOBEEP Specifies not to beep when a storage card is installed.
When this parameter is not set, you will hear a beep every
time a storage card is installed into the PC Card slot.
/STBTIME:
n Specifies the time (from 1 to 21 minutes) until entering
standby mode. When the ATA card is not accessed for the
time specified by this parameter, the ATA card enters
standby mode (only when your ATA card supports standby
mode). When this parameter is not specified, standby
mode for the ATA card is disabled.
/MDRV:
n Specifies the number of extra drives that can be used in
addition to the number of PC Card slots available for the
PCMCIA storage devices. When this parameter is not
specified, no extra drive is given to the device driver. The
extra drives can be activated by the PCMCIA ATA Card
Mount Utility.
Appendix B. Advanced Information for PC Cards 285

IBM THINKPAD S05L-1270-01 Specifications

General

Brand	IBM
Model	THINKPAD S05L-1270-01
Category	Laptop
Language	English