Installing Windows NT Workstation Software
Installing Microsoft Windows NT
Note:
You can install Windows NT using a
built in CD-ROM drive or the
CD-ROM drive of the SCSI CD-ROM
in the IBM docking station.
Before Installing Windows NT
You need to read the following before installing:
Review the Windows NT installation guide. If you need to
use such PC Card hard disk drives (such as the IBM
105MB/260MB hard disk drive, Integral Peripherals Viper
105MB/260MB disk, Maxtor Mobile Max131, or the other
PCMCIA ATA storage devices), insert it in the PC Card slot
before
you start the Windows NT installation.
Windows NT recognizes the PCMCIA hard disk only at
installation to set up the necessary device driver.
Install Windows NT with Custom Setup and specify the
video display as Standard VGA (640x480, 16 colors).
Otherwise, the screen might black out when you start
Windows NT 3.51 the first time after the installation.
To install Windows NT, refer to the installation instruction for
Windows NT.
Note:
When you install a later version of
Windows NT 3.51, you do not need
to follow this instruction about a
video problem.
Installing the Video Features Diskette for Windows NT
To display more than 16 colors, install the Video Features Diskette:
1
Start Windows NT, and log on with the user ID authorized as an
administrator.
2
Click on Control Panel and then Display.
3
At the Display Setting menu screen, click on Change Display
Type..., and at the Display Type menu, click on Change.
4
Click on Other... at the Select Device menu.
5
Insert the Video Features Diskette for Windows NT in the
diskette drive.
6
From the display devices in the selection list, select IBM
ThinkPad (Cyber9320/9385/9382) and click on Install.
7
Follow the instructions on the screen.
218
IBM ThinkPad 760E, 760ED, or 760EL User's Guide
To Next Page
Loading...
Need help?
General
