IBM THINKPAD S05L-1270-01 Instruction Manual

Troubleshooting
Enhanced Video/MPEG Feature Problems
Docking Station Problems
Problem Cause and Action
The Enhanced Video
function or the MPEG
function does not work.
Verify the Enhanced Video is enabled and no resource conflicts (IRQ or I/O
address) exist by doing the following:
1. Select the Enhanced Video (
) icon in the ThinkPad Features
program.
2. Click on Advanced..., and make sure at least one IRQ is assigned for
the PCI devices.
If you find any conflicts with other devices, change the value to avoid
any conflicts (see page 267).
The MPEG playback and the video capture functions use the same
hardware resources. Only one of the two functions can be used at the
same time. For the same reason, two MPEG functions cannot be used at
the same time.
Problem Action
SCSI devices in the Dock
I or Dock II do not work.
Verify that:
SCSI devices are installed correctly. (Refer to the user's guide for Dock I or
II.)
IRQ level for the SCSI controller does not conflict with the system resource.
– To change the SCSI IRQ, refer to the user's guide for Dock I or II.
– To change the system resource, click on the Docking Station (
)
icon in the ThinkPad Features program and click on Advanced and PCI
device setup; then change the IRQ level.
The IDE CD-ROM drive or
hard disk drive in the
docking station
(SelectaDock Docking
System, Dock I, or Dock
II) does not work.
Verify that a secondary IDE device in the docking station does not conflict with
the system resource:
1. Start the ThinkPad Features program.
2. Click on the Docking Station (
) icon and put a check mark by Enable
secondary IDE device.
246 IBM ThinkPad 760E, 760ED, or 760EL User's Guide

IBM THINKPAD S05L-1270-01 Specifications

General

Brand	IBM
Model	THINKPAD S05L-1270-01
Category	Laptop
Language	English