EasyManuals Logo
Home>Intermatic>Control Systems>PE653RC Multi Wave

Intermatic PE653RC Multi Wave User Manual

Intermatic PE653RC Multi Wave
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
Four: Programming the PE953 Hand-Held Controller 51
Providing a brighter solution.™
Cut out a knock-out for the wire to pass through the cap, 5.
then screw the antenna cap to the bracket, using the screws
supplied with the remote kit.
Cut out a knock-out for the wire to pass through the dummy 6.
cap, then screw the dummy cap to the top of the PE653
Receiving Device, using the original screws.
Labeling the Hand-Held Controller
Intermatic provides a sheet of peel-and-stick labels to use in identifying the five buttons on the
Hand-Held Controller. When installation is complete and the system has been programmed,
apply the appropriate stickers to guide the owner in using the system. For additional stickers,
contact Intermatic Inc., at 815-675-7000.
Depending on which components have been installed in the system, you have several choices
for which screen you want to use as the default primary screen (displayed when the Hand-Held
Controller awakes from sleep). This decision may determine which labels you might want to
apply to the Hand-Held Controller.
Labeling for the PE653 Screen
If you set the PE653 screen as the primary screen, the five buttons on the Hand-Held Controller
are usually configured as follows:
Button <1> = Filter Pump
Button <2> = Filter Pump low speed for two-speed systems, or available for generic
assignment
Button <3> = Cleaner Pump, or available for generic assignment
Button <4> = Pool/Spa control actuators, or available for generic assignment
Button <5> = Heater, or available for generic assignment
Labeling for the Z-Wave Screen
Label the five buttons according to the names of the five scenes.
Labeling for the Variable-Speed Pump Screen
Label the five buttons according to which speeds you have assigned to specific functions, as
identified on the screen.
Labeling for the PE650 Screen
Label the five buttons according to the functions assigned to the circuits in use at the installation.
Variable-Speed Pump
Main Screen
PE650
Main Screen
Z-Wave
Main Screen
PE653
Main Screen

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermatic PE653RC Multi Wave and is the answer not in the manual?

Intermatic PE653RC Multi Wave Specifications

General IconGeneral
BrandIntermatic
ModelPE653RC Multi Wave
CategoryControl Systems
LanguageEnglish

Related product manuals