8 Multi-Wave PE653-PE953 Installation Guide
Copyright © 2010 Intermatic, Inc.
Section 1:
System Overview
The Intermatic Multi-Wave Pool/Spa PE653RC Wireless Control System brings wireless control to
a new level of simplicity and affordability. The following features make the system distinctive:
Easy to Use — with simple, push button controls and a clear, easy-to-read display panel•
Everything You Need — includes the functionality and control called for in nearly every •
installation.
Dependable — with Z-Wave•
®
technology that lets you expand your system with
inexpensive repeaters that plug into available electrical outlets to help extend the RF signal
range of the entire system. Z-Wave technology eliminates intermittent signal problems
experienced with many other systems.
Cost Efficiency — a superior system, easier to install and maintain, with better •
dependability, and at a cost that’s competitive with any other system available.
The standard configuration for the Multi-Wave PE653RC Pool/Spa Wireless Control System
configuration is shown in Figure 1-1. You can order individual components for a custom
configuration or system as indicated.
Z-Wave is a registered trademark of
Sigma Designs and/or its subsidiaries.
Figure 1-1
Weatherproof outdoor enclosure
can be mounted directly to an
existing enclosure.
Antenna can be remotely located
using a Standard Cat 5 Ethernet
cable with RJ45 plugs.
Terminals for two-wire
connections to remote
temperature sensors
Internal selector switch for
120 / 240 VAC operation
Metal Indoor/outdoor enclosure
provides for easy and secure
mounting and a large space for
conduit wire connections.
Receiving Device (PE653)
Two-wire connection (RS485) for
control of variable-speed motors
Approved snap-in wiring
separator for use with low
voltage heater control circuit
Hand-Held Controller (PE953).
Additional units can be
ordered separately.
Offers timer capability and can
control up to five preprogrammed
configurable circuits.
Spare 0.10 Amp Fuse
To Next Page
Loading...
Need help?
General
