SV-DA200 series AC servo drive Function codes
-133-
6.4 I/O management parameters (P3)
6.4.1 Digital input/output
Input configuration of
digital input 1
This parameter is used to select the configuration of the digital value 1 input function. It is a hex
number.
0x——: means the valid mode: 0: optical coupler conduction valid; 1: optical coupler
non-conduction valid.
0x—: means the selected function, the detailed information is as below:
Optical coupler
non-conduction
valid
Optical coupler
conduction
valid
Positive direction drive disabled
Negative direction drive disabled
Internal position command 1
Internal position command 2
Internal position command 3
Internal position command 4
Molecule 1 of electronic gear ratio
To Next Page
Loading...
Need help?
General
