SV-DA200 series AC servo drive Appendix
-293-
EEPROM fault–Read-write fault
EEPROM fault–data check fault
Hardware fault–FPGA fault
Hardware fault–Communication card fault
Hardware fault–Grounding short circuit fault
Hardware fault–External input fault
Hardware fault–Emergency stop fault
Hardware fault–485 communication fault
Software fault-Motor control task re-entry
Software fault–Reentrant cycle mission
Software fault–Illegal operation
IO fault–Digital input distribution repeated
IO fault-Repetitive analog input distribution
IO fault–Pulse input frequency is too high
Main circuit overvoltage fault
Main circuit undervoltage fault
Undervoltage fault of control power
Motor overtemperature fault
Speed fault–Overspeed fault
Speed fault-FWD overspeed fault
Speed fault-REV overspeed fault
Speed fault- Overspeed parameter setup error
Position overtravel - FWD overtravel
Position overtravel - REV overtravel
Hybrid control deviation is too large
Position increment overflow fault
CANopen fault–Sync signal timeout
CANopen fault-position command buffer full
Drive overtemperature fault
To Next Page
Loading...
Need help?
General
